Bruma Sconce

Parts

Installation instructions

Step 1

Disassemble Bruma. Unscrew wood cover and slide glass shade off of pipe.

Step 2

Unscrew LED Lens and slide Wood Ring off of LED Module.

STEP 3

Assemble Bruma. Using the provided lever nuts, connect the LED module to 120VAC power.

Step 4

Attach LED module to standard 4" j-box with two #8-32 screws through the universal crossbar.

Step 5

Thread LED Lens onto LED Module until Wood Ring is secured to the wall.

Note: the LED Lens is directional. The face with the smaller diameter faces the LED Module.

Step 6

Slide on Glass Shade and twist Wood Cover onto pipe until finger tight.

Care & Cleaning

To properly clean without damaging the wood, it’s best to follow the assembly instructions and take apart before cleaning.

To clean wood, use a cloth dampened lightly with water. The cord may be wiped with a dry cloth. Avoid getting cleaner or moisture on the cord.

To clean glass, spray a microfiber cloth with a 1:1 mixture of vinegar and water. Wipe down glass and repeat if needed. Remove any streaks using a dry microfiber cloth.

Recommended Dimmers